You have a working configuration in VPN Tracker and want to move it to Shimo? See the guide below to find out how to configure the settings in Shimo.

1. Open Shimo Preferences and go to Accounts

2. Click the + button to add a new VPN account

3. Select General IPSec and click Create… (If you are using Cisco, Nortel or Juniper/Netscreen IPSec refer to the appropriate guide)

4. Provide the information for Remote Host (this is called VPN Gateway in VPN Tracker) and Username and Password if necessary

5. Double click the account you just added to configure it further

6. Open the configuration in VPN Tracker to compare it with the settings in Shimo

7. Select and enter the appropriate Local and Remote Identifiers

8. Select the right Authentication Method and fill in the necessary information and provide the path to the certificates if necessary

   1. Pre-shared key -> Preshared Key
   2. Certificates -> Certificate
   3. Hybrid Mode -> Hybrid RSA
   4. Pre-shared key with XAUTH -> XAuth PSK
   5. Certificates with XAUTH -> XAuth RSA

9. Select if you want to Use remote DNS servers

10. In case you want to specify the DNS servers or only use them for search domains apply the appropriate settings e.g.

11. Go the Advanced tab in Shimo and stay on the Basic tab in VPN Tracker

12. Provide the appropriate settings for the Network Configuration in Shimo

13. Select the right Topology in Shimo by selecting the Local Endpoint Mode and the Remote Endpoint Mode

14. Add the right IP Addresses if necessary

15. Now go to the Advanced tab in both applications 

16. Select the right settings in Shimo

17. If you have any custom routes specified in the Traffic Control in VPN Tracker, add the same routes to the Network Traffic Control in Shimo (select Overwrite as the mode)

18. Go to the Expert tab in Shimo and scroll down in the Advanced tab in VPN Tracker

19. Compare the appropriate settings

20. That is it. You should now have the same VPN account working in Shimo.